Ultra-Pitch Mod: Numark PT-01

ULTRA PITCH MOD: NUMARK PT-01

This Kit is designed for both the Numark PT01 Non-USB or USB. The Kit is configured to go inline between the Motor and Circuit Board. Soldering iron is not needed for this installation.

PREREQUISITES

Drill / Electrical drill
Step drill bit
Dremel (Optional)
Wire Stripper that supports 22 awg and up
Pliers
Electrical tape

STEP 1

Flip the turntable over to rest it on the top cover and remove 8 screws using a philips screw drivers or using a drill with a philips drill bit for faster access.

STEP 2

Detached the power and usb plug from the bottom portion of the portable turntable.

STEP 3

Choose an Area to drill a hole for placement of the ultra-pitch kit. We recommend using a step drill bit. Do your best to not over drill the hole.

STEP 4

With wire cutters or scissors cut the Motor wires at about the center.

STEP 5

After you cut the wires you’ll need separate and strip the 4 wires (2 x white & 2 red/white) on the portable turntable using a pair of wire strippers.

STEP 6

The motor has engraved the + and - Symbols for Positive and Negative. The Red with White Stripe Wire is Positive and Solid White Wire is Negative.

WIRING DIAGRAM

Use this diagram to match and connect each of the wires in steps 7-9.

STEP 7

Insert the Solid White Wire (Negative) coming from the circuit board into one of the orange wire butts included in the kit. Note: Refer to the wire diagram to properly match the colored wires from the Ultra-pitch kit to the motor and circuit board.

STEP 8

Connect the Black Wire from the Kit to the Solid White Wire (Negative) coming from the circuit board into one of the orange wire butts included in the kit.

STEP 9

Using a pair of pliers, snap the orange button on the wire butt down to lock both wires into place.

STEP 10

Gently pull on the wires to make sure they're secure and don’t come out of the wire butts.

STEP 11

Detach the Ultra-pitch knob, nut and washer from the Ultra-pitch kit.

STEP 11

Insert the Ultra-pitch kit into the hole you just drilled.

STEP 12

Insert the Ultra-pitch kit into the hole and screw in the included nut with your hands or using a 10mm socket.

STEP 13

Take some electrical tape to tape down any excess wire laying around with inside the turntable.

STEP 14

Plug the power and usb wires back into the bottom portion of the turntable.

STEP 15

Before screwing in the turntable, plug the power adapter or insert batteries into the turntable to test the Ultra-pitch kit. Make sure it’s functional and no wires had accidentally been detached from the Ultra-pitch kit, motor or mainboard.

STEP 16

Once the Ultra-pitch kit mod has been successfully installed place the bottom of the turntable back onto the turntable and screw the 8 screws back in using a philips screw driver or electrical drill with drill bit.

STEP 17

Enjoy your new Ultra-pitch kit mod!

Ultra-Pitch Mod: Numark PT-01